LightingWill 2inch LED Dimmable Downlight, 3W COB Recessed Ceiling Light, Daylight White 5500K-6000K, CRI80, 25W 220LM Halogen Bulbs Equivalent, White (10 Pack)

They look really nice , specially when they’re dimmed. I would recommend this lights.

Very good quality

Easy install. 60 days going strong

Two thumbs up

Works great.

Just what I wanted

At first I was worried about the lights each needing their own junction box in the attic to make them up to code. Then I decided to barrel crimp the low voltage side of the little drivers and run an extended piece of low voltage wire so I could po it all the drivers in the dame box. I used a 2g nail on to a rafter and landed the drivers in their with a 2g switch plate for ventilation. Lights are brighter than I imagined and with a 2in hole saw and a little love tap to get them up into the ceiling they look and fit great! Any questions send me an email [email protected]

I had existing old ceiling lights. I measured and these were a good fit. I replaced the old ones with these. They fit great and look good. They are way brighter but worked well for me.

Parfait , installation rapide et description conforme, je recommande !

I was replacing two old lights, I plugged in the old wires but had no luck. I called an electrician, luckily he was out of town. I'm not a patient man, so I opened up the junction box above the vanity and I saw an old tranformer that had to be removed. I removed the old transformer and everything worked like a charm. The lights are beautiful and bright, exactly what I needed!

I had to use 54mm wood bit instead of 51mm as described due to the slightly bulky springs that locates the light into the cupboard.

Easy to fit and super stylish but of the 6 I installed yesterday three of suffered driver failure. Boom!

Not bad for a small light Angle does look a bit wider than 36 degrees but that is hard to tell. I will use them again. Connectors are bad but you can just take them out and use your own. I saw on some reviews they need 54mm hole instead of 51mm hole but i used my 51mm (2") bit and gently punched it in. Makes it tight fit. It could be a bit confusing for DIYers but for people who are used to them will get it easily.