KOYOFEI 5PCS Screen Protector for LCD Resin 3D Printers, Screen Protective Film for Elegoo Mars2/2 Pro, Photon Mono/Mono SE, Voxelab Proxima 6.08 inch Monochrome LCD Resin 3D Printers

Purchased for Anycubic Photon Mono M7 Pro. This is a very good and affordable set of screensavers for your 3D printer. Several screensavers I have tried were only large enough to cover the LCD screen (seen by the red line in the photo). They do the job, but if you have a puncture from a failed print (like I did) near the edge, there is a good chance that your resin could seep under the screensaver and get around the edges of the LCD screen itself -- potentially leaking into your internal components. That is why a screensaver of this size is needed (seen by the blue line in the photo). It will cover and protect nearly the entire surface of your print field, all the way out to the vat screws and posts. So don't take a chance on the smaller 10.1" versions. This is the type of screensaver my printer was originally supplied with, and you will get the best margin of safety.

Goes on smooth with no bubbles. Protects well and doesn’t affect clarity.

Worked great. Don’t forget to get some of the black tape stuff.

Seems a tiny bit undersized for a Phrozen Sonic mighty 8k. It's best to install this *before* the tape around the LCD. Kapton tape works great for that purpose.

These are easy to install and make mistakes of resin tray leakage a worry of the past! Unfortunately, if you mess up the application you have to start over, but if you follow the instructions it's easy as can be.

Everything about this pack was above expectation! I’d definitely recommend and purchase again. Works better than expected! Great value too!

For a company that sends a note with their product claiming to be "a company specializing in R&D and sales of 3d printer accessories." I ask you this, Dear KOYOFEI, Did you test this product on at least a single mars 2 pro before claiming it works with it? Confirmed this 6.08" size screen protector will NOT fit properly on the Elegoo Mars2 Pro. the film will not settle fully on the screen. leaving an easily pealable edge around all edges, (only two if you aline one corner perfectly.) in turn will allow resin to seep under the screen protector. i am attempting to use blue painters tape to hold/seal the edges of the screen protector (painters tape not included) I am considering on attempting to cut down one of these with a large paper cutter, in an attempt to get the correct fit.

I have a Mars 4 9k, and the issue is that the screen has some black sealing tape around it to seal the edges around the LCD screen. This protector is larger than the available screen so it sits on top of the sealing tape and causes bubbles on the edges. "Just put it under that tape" you say? Well then when it's time to replace this protector, you have to pull of that sealing tape and it's a 1 use tape. This product should have 5 sets of screen sealing tape that come with it so we can replace it when we replace the protector.