SDTC Tech 4-Pack 90 Degree Fitting Hand Twist Elbow for 10mm ID, 14mm OD Metal and PETG Rigid Tubing Computer Water Cooling System Connectors

Worked good. Looked good

Just what I needed to join two hard tubes together in my cooling solution. Works good with no leaks. Reasonably priced for my budget also.

Quality isn't very good. It was way too easy to push on or pull off even with the locking ring tight and even tried thicker o-ring to see if it would make a difference and it did not. When i pressure tested my loop one of fittings popped off the 14mm hard line at 0.3 bar, suppose to leak test at .5 bar. The fitting looks fine from a few feet away but as you get close you can see unpainted spots on the lock ring where tabs were holding the locking ring during manufacturing, so your left with 2 bright white spots on a black locking ring. These were less than half the cost of the Corsair fitting and they aren't really worth that price, and I ended up returning these and getting the corsair 90's.

I had no issues with these, used a bunch of them in my build. No leaks, nothing. They work well for the price.

The 3 O-ring system give you peace of mind with leaks or becoming loose. Helps to complete your loop for those tight bends.

differ from the original, the original weighs 49 grams, and these 35 are not painted well enough, the fillings are a bit harsh, but you can take them 👌

Aesthetically these are nice, it is a simple concept for a compression fitting that just doesn’t execute well. Every leak point I have on my system I have tracked to one of these fittings. The depth if the fitting is quite shallow on the o-ring doesn’t seem to create a tight seal when compressed into fitting. The tubes turn easily inside of these and you can pull them out after tightening the compression very easily.

I will continue to use these in every hardline watercooled build i do. Theyre way cheaper than corsairs ugly 90 degree fittings