GE Security Interlogix 600-1064-95R

Need another one for my Alarm system. This worked just fine switche'd out the insides. My old one hole waa broke and co put on my Keychain

Great replacement for old Interlogix remote. Added easily to Concord 4 system. Works great. Pay attention to earlier review on sensor groups in Concord 4. Must be unmonitored group or you get a daily error beep. Double check it after adding.

Had an older version of this fob break where it connects to the key ring. Wasn't in the best either as the symbols had worn off of the buttons long ago. Concerned the symbols will rub off on this one too. This fob is a replacement, and seems to work better than the original. The button operation is more precise and seems to work well. The $23 price with shipping and tax included sure beat the $99 price asked for by the monitoring company for a replacement. Was expecting possible resistance by the monitoring company as far as helping me sync this my system (Simon XT). They were willing and I was able to program correctly...almost. Unfortunately, I started getting warnings that the fob was "offline" every 12 hours. By pushing the disarm button in the alarm, the fob would then go back online. No one at the monitoring company (talked to 3 different people) had ever heard of this problem, and I was close to having to call for a costly service call. Called a 4th time and got somebody who knew exactly what the problem was. Turns out that the programming steps I got weren't exactly right. The fob was put into a "sensor" group and the base unit was expecting to get a ping was the fob. It was put into the correct non-sensor group, and all seems know.

Works great with the GE Concord 4 alarm system. Find install/program instructions for your particular system on Google. Master program is usually 4321. Installer (ADT) changed mine to 6321. So key sequence is 8-6321-0-0. Under "sensor" menu, select "sensor learn" and with "trip sensor" is displayed (remember which sensor number is assigned ie: S6), press and hold on and off buttons on keyfob. The alarm system will beep. Then you have to go back to "sensors, edit" scroll through sensors until you find your new entry, choose "partition 1" and "group 1". Very important you choose group 1. Group 0 is "supervised" and is polled every 64 minutes, you will get a sensor error code because keyfobs do not respond back to a system poll. Group 1 is unsupervised, therefore, group 1 does not poll and expect a response back from the keyfob or any other device assigned to that group. Again, this works with the GE Concord 4 system and probably will be very similar with other systems. If your installer changed your installer code (I understand most of them do) try: 4321 or 6321 or 1676 or 1626 or 9317. My searching the Internet came up with these codes, suggest you make sure you can enter programming mode BEFORE you buy a keyfob. This one works great and very good price. Also works: 600-1021-95R, 600-1022-95R and the 600-1040. Hope this helps

I worked but stopped 4 weeks in use. Maybe I got a bad one but it worked for GE Simon 3 system.

This fob is 1/3 rd the sized of my old fob, yet the buttons are bigger and easier to find in the dark. The install was very simple to my Simon (GE) 3 was quick and painless, also this fob is IP55 rated witch might survive a swim in the washing machine witch my old fob was not (hint on how my old fob meet its end). Very nice improvement over the old fob.

It worked for about a week. Then we replaced the battery and it worked another week. So we replaced the battery again and it died again. Tried replacing yet another battery and now it doesn't work at all!!! Can't return it now because we've had it over 30 days!!

Does what I need it too. Slimmer than the original fob.