daier 20 Sets Mini Micro Sh 1.0 Jst 4-Pin Connector Plug Male with 150mm Cable & Female

I mistook the connector that I needed for the one here so I haven't gotten to use these, but they are as pictured and seem sufficiently well made. I will keep these for any future projects that I may require such a connection for.

0.9mm OD PVC jackets, so most likely 28AWG, not 26AWG as advertised. I don't think you could get a 1.0mm OD 26AWG into the JST SH connector... there just isn't the space.

Good connectors and pig tails. Couldn’t use them as they were to small.

I accidentally ripped the jst connector on my keyboards daughterboard and this was an easy to replace connector. Note that these would be perpendicular to the pcb.

Not what i was expecting. Much smaller than i realized. Not sellers fault, only my own.

I had to search a bit for these, they fit my Treedix 2pcs 2x20 GPIO Header Connection Ports PI Hat GPIO Breakout Board GPIO Connector boards just fine!

Well made. Cleanly terminated. They used the right connector. Good product.

Ok

Works awesome but had to swap the wires areound for my use.