YESWELDER Magnesium Aluminum Welding Wire, ER5356 .030-Inch Diameter, 1-Pound Strong ABS Plastic Spool MIG Wire

Wire works great flat and down hill. Uphill might just be out of my wheel house. Overall, I would buy again.

fast service, everything it should be, thank you

Yes for win. This is my go to for my aluminum spool gun now. Good on new and use aluminum.

I have not utilized it as of yet, due to not having argon at this time. It appears as it will do the job as desired. it is thin wire, much smaller than regular mig wire. Using it will be some what of an experiment when I get around to it.

This wire was an experiment to see if my cheapo mig machine (HF) would weld aluminum. I have tried tig welding aluminum, but very tricky and learning curve to achieve good results long. So, I decided to try the mig route. Some process notes: Clean, clean, clean......the material first with a dedicated stainless steel brush, then wipe down with acetone. Use 100% argon gas 25-30 cfh, set feed speed higher than your used to with mild steel and be prepared to push feed quicker than your used to. I also preheated a bit with propane torch. Amp setting will have to be experimented with but I got good looking welds with good penetration on 1/8 inch material at about 75 amps. I had no trouble at all with feeding the .035 wire using a 10 ft lead, but keep it as straight as possible to avoid kinking the wire. Very satisfied with product.

So it worked for holding it. But i haven't put it to the stress test yet. We'll see

Currently on my 10th roll it works great.

Great quality wire !!! Welds like a dream

recommended by the HZXVOGEN 250A mig welder , but doesn't work that good on 6061 aluminum .the forney 42296 wire works better

Trop cher moitier prix local