Ogrmar Automatic Boat Bilge Pump Float Switch Moisture Tight Seals 12/24/32VDC Ignition protected Mercury

Muy buen producto

Most float switches available now are very poor quality. Jabsco, Johnson versions are genrally poor, attwood make a decent one but cost is well over double of this one. I reckon you'll get 1-4 years off most on the market MAXIMUM. However, most pumps fail due to poor wiring splices or crimps, so I would use these over a $60 one and use resin connectors and/or heatshrink. Don't over-torque the screws when you fit them to the bilge or the bracket. I would always fit these to a thin/long basic 'L' shape stainless bracket that holds it low in the bilge, for easy install and replacement. Durability 4 stars is because they're all made poorly now, mine are holding up well so far.

Good

I replaced an existing float switch of a different brand. Just separated the float from the mount, installed the mount, clipped the float to the mount, and spliced the wires. Took no more than a half hour.

Works as advertised. Easy direct replacement for the more expensive Rule float switch, and at a much better price. Hoping it will last as long at the name brand...

Did the job

The description shows like it turns on when is up and off when is down, well the switch that I received works back-guards is close when its down. I did make it work for what I need it but the electronic circuit is always on. I am going to try another brand name switch, I believe it is defective. I tested with a multi-meter and it should work the other way. Plus it is not reversible because it has the wires on top and should be out of the water.

Works but it’s poor quality very fragile I’ll probably have to replace it in a few years

Not perfect, but useable