423360-7 Rubber Splinter Guide

I bought this for my Festool 1400/2 guide rail, I was initially skeptical about not choosing the genuine Festool version. However, at a third of the price, it was worth a try, and there’s enough to cover two 1400mm guide rails too. After removing the old splinter guard, I cleaned the rail with a Big Wipe, but the residue prevented proper adhesion. I then used rubbing alcohol on a microfiber cloth to remove the residue, and it then adhered perfectly. When trimming it down with the track saw, I noticed a difference from the Festool version. Instead of cutting off a strip, this one turned into crumbs which made a rite mess despite being attached to the extractor. First use was on 6mm MDF, it was easier to line up and delivered results that, in my opinion, were better than the genuine Festool version. It’s also noticeably sturdier.

Got this for my dewalt guide rail. Was going to pay £30 for dewalt own until I saw this. Fits perfectly, adhesive seems good. Trimmed down beautifully. And the 3rd of the price. Some have said it comes up short in length. Mine was about 3050mm Will be buying another one.

Used on my Dewalt plunge saw track. Perfect fit and works brilliantly.

Bought to replace splinter guard on 2 x 1.5m Makita guide rail / tracks. Tracks were connected together and new splinter guard applied (old adhesive removed with stanley blade) . Quick check before fitting and length seemed to be OK, however upon fitting and despite starting dead size (no overlap) found it was approximately 25mm too short. Laid in place to avoid stretching - perhaps stretching is required? Typically with rails this long 2 passes are needed where the track is split and joined together again to pick up the untrimmed start/end of each track. This means that the gap is in the centre adjacent to the track joint.

Great consumable for your track. Unlike some others , this one has some flexibility. Swapped out OEM guards on all my rails for this one. Good adhesion - enough to allow re-positioning/trimming if you just ding a small part.

Purchased this to replace splinter guard on my Evolution track. This is much better than the original which was forever coming loose. Good price, compared to some on the market, more than long enough to cover my 2.8m track with some to spare. Adheres really well to the track and have had no problems at all with it. This will be my go to for a replacement in the future Highly recommended

Worked well happy with it

Cleaned the track thoroughly before fitting, perfect

Très bien, remplace celui du guide Bosch

Passt perfekt auf die Makita Führungsschiene. Habe das neue Band in 3 m bestellt, passt so auf die 1,4 und 1,0 er Schiene und ist günstiger als fertig zugeschnitten. Außerdem hat man beim aufkleben mehr Spiel. Das entfernen des alten Kantenschutzez wahr aufwendiger. Das Gummi ging leicht ab, aber für den Kleber empfehle ich Bremsenreiniger und einen Klingenschaber mitPlastikklinge. Zeitaufwand für beide Schienen ca 1 h.

Todo salio bien

Reçu rapidement il s'adapte parfaitement à mon rail (Métabo) et même le Parkside !

Perfetta per guida originale sega ad immersione Makita