2 Jack Pad Adapter Rubber Jack Pads for Jack Stands Jack Pads Pinch Weld Slotted Frame for Jack Stand General-Purpose Rubber

I like my Jack Pad Adapter. It fits on my Harbor Freight three ton jack stands. It holds up my Subaru and Honda CR-V well without damaging the pinch weld.

It fit just well on the jack stands I purchased on Amazon, and did its job both securing the vehicle from slipping and protecting the paint on the chassis. Very satisfied.

I have two different pairs of jack stands and they slip on perfectly. Big Red and Harbor Freight. Both have slightly different grooves at the top and these are a little sharper on the groove to fit "perfectly" but honestly it's up to interpretation. It does fit well with only slight movement. Its does work on many different types of groove type jacks and I think that's the best part. Cons. First use caused a slight split in the rubber. Making it where I'm not sure how long they will last. But it is a solid material and feel it's just breaking in kinda thing. After multiple uses it didn't split more so I'll stick to it being a lot of pressure initially.

They fit a tad bit loosey-goosey on my jack stands which I could probably correct with a little foam on the inside. But once pressure is applied they stay in place just fine and work great keeping my jack stands from tearing up the rail where the lifting points are on my van.

It fits various jack stands very well but the rubber is too soft & breaks.

Used it for about 2hrs while I doing some maintenance on my 2014 beetle. No cuts in the plastic and if anything it removed some old debris stuck to the pinch point. Set it a little higher because it will sink slightly.

Fit my jack stands perfectly. I'm not sure they will fit all other jack stands. Seemed sturdy enough for me, a local backyard DIY car mechanic.

Not recommended for jacking up a BMW