ELLETIPI Ecofil PF01 44B2 Pull-out Differentiated Waste Bins for General Waste, Plastic and Metal, Grey, 30 x 45 x 46 cm

I bought these bins for a half width standard cupboard unit and they fit perfectly. Installation is quite fiddly, but the bins obviously come out of the frame and in turn the frame does unclip off the sliders. This makes it so much easier to install and once you figure this out, it suddenly becomes fairly simple task as there are only four screws (included) to do up, although there are 12 screw positions possible. I went with 8 screws, just to be safe. Essentially, take the bins out, and place the whole frame and runners in the cupboard where you want it to be (at least three centimetres from the front) and mark with a marker pen where the screws need to go (you may have to slide the fame along the runners a little to mark all four positions). At this stage, leave the frame/runners where they are and close the door to make sure the door doesn't clang on the frame when you close it as this will be very annoying and eventually drive you insane - unless you're deaf, in which case you'll be okay... Once you have done this, remove the whole thing from the cupboard and carefully remove the bin frame from for the four plastic runner holders, leaving you with just the runners to deal with when you actually screw the screws in. Take your screws and then tap them into the marker marks with a hammer so you're not trying to screw into a flat/smooth surface in a small space. Slide the runners back into place and tighten the screws up (not too tight at this stage, but tight enough to hold everything in place. Carefully clip the frame back into the runners and slide in and out to see if the fit and run is okay, if it is, remove the frame again and fully tighten the screws (you may be able to do this without removing the frame if space allows), replace the frame (if you took it out) and put the bins back in - job done! Go you! If not running smoothly, loosen the screws a little and slide the frame (on the runners) in and out until they find their own position, then fully tighten the screws as above! Reading the other reviews I was prepared for the rear bin not to come out, and as I have a regular under surface cupboard with a drawer above, this is indeed the case. To overcome this, we just use the rear bin for domestic waste, put a bin bag inside and just remove the bag when it's full rather than try and remove the whole bin. We use the front bin for recycling and are able to remove this whole bin when it's full - simples!

Overall, we are very satisfied with the product, it does the trick and works as planned. Pros: - High quality metal structure, slides in and out without making any noise and stays in place firmly. - Fits well under the sink in the cupboard as intended. - Easy to install with 4 screws - just had to drill holes into the wood so screws grip (tools aren't included!). - Good size bin containers, fits up to 35l bags. - Loved the coloured labels which fit perfectly on the lids. Cons: - Cheap container handles, they fall off occasionally. - When fixing the bin bags with the container handles, the two containers don't fit very well and need to be squeezed in a bit - not a major issue, once done everything stays in place, but a bit of a hassle. - The metal structure doesn't extend enough for us to remove the inner bin container completely - only when removing the metal structure completely it is possible. Again, not a major issue and still possible to change bags/clean the container, but it limits the functionality of the otherwise smart design.

Poor quality and very flimsy. The drawer runners have both bent in under 3 months of use. The plastic most continuously cone loose. The fixings supplied are poor quality and too weak. Avoid

This is a very good, well made product however, it wouldn’t slide out from my cupboard enough to remove the rear bin from the frame.because of this I had to remove the central strengthening bar with a hacksaw and file the edges smooth. It is now perfect and it’s strength was not compromised. It was easy to install and has a very smooth movement.

Fantastic design, great price, very easy to install, very smooth on the runners, just the right size to fit in the cupboard out of the way. Have to empty it more than our old one, but who cares it is out of the way to love it. does exactly what it says on the tin.

Really nice design, easy enough to install. HOWEVER, the bin itself at the back is not able to come out unless you unscrew everything. The bins sliding mechanism doesn’t come out far enough to allow you to simply lift it out.

Pretty tricky to install but seemed ok once it’s done. As many have said getting the bin at the back out once it’s installed in your cupboard is impossible. Sadly it has fallen off the rails after only 6 months. Would like a refund.

We have had ours for nearly 4 years and cannot complain. Great space saver and convenient if you want to hide your bin. Obviously if you put the heaviest of the 2 bins at the front, then it’s probably going to break like others have said. However if you use some common sense and put the heaviest bin at the back, it will last as long as ours has :-) would definitely purchase again

Ya tenía uno del mismo tamaño con tres cubos, uno de 24 litros y dos de 8, y ahora he instalado otro con dos cubos de 24 para completar las posibilidades de reciclaje. Ahora utilizo los tres grandes para orgánicos, envases y cartón, y los dos pequeños para botellas de vidrio y cápsulas de café. El producto tiene una buena relación calidad / precio en mi opinión. Es cómodo en el uso, las bolsas se ponen fácilmente con un poco de práctica y parece bastante resistente, el tiempo dirá. La instalación es relativamente fácil. Yo recomiendo poner la estructura sin cubos marcar las posiciones de los tornillos retirar la estructura y poner los tornillos hasta la mitad clavandolos un poco previamente con un martillo. Después poner la estructura y apretar. En mi opinión con los cuatro tornillos que trae es más que suficiente. Veo que hay gente que no ha puesto las asas. Son importantes peor porque permiten sujetar bien las bolsas, no sólo retirar los cubos. El único pero que le pongo son las tapas, que con las bolsas puestas quedan justas y es fácil no encajarlas bien con las prisas, y en el caso de los residuos orgánicos generar malos olores.

I secchi son capienti ed il problema dei coperchi difficili da prendere si risolve con 2 pomoli. Le guide funzionano bene anche se personalmente avrei fatto meglio e più robusta la struttura che le accoglie e che si fissa al piano del pensile. Se uno ha un po’ di manualità con il fai da te é possibile comunque ricrearlo più robusto e con altri materiali. Nell’insieme svolge in maniera eccellente quello per cui l’ho acquistato per cui sono pienamente soddisfatto.

Dans une cuisine avec peu de place, la gestion des poubelles, et en particulier du tri sélectif, devenait contraignante. Tout est devenu beaucoup plus simple avec cette double poubelle sur rails. Le montage est très simple, il n'y a que quelques vis à fixer. Comme évoqué dans d'autres commentaires, les supports de fixation en plastique semblent un peu fragiles, mais devraient supporter quelques kg de poubelle sans grande difficulté. A voir cependant sur la durée. Les poubelles s'enlèvent et se remettent très facilement dans le support, et la fixation du sac poubelle avec les anses de chaque bac est très pratique

Zeer tevreden van mijn aankoop. Ik heb al reeds een tweede aangekocht!

Sehr hochwertige Qualität, passt genau... Einfache Montage mit den 4 mitgelieferten schrauben.