HYPERLITE - 120W LED Wall Light Pack, 2 Pack with Dusk to Dawn Photocell and Glass Lens LED Security Lights Outdoor Commercial Industrial LED Lights

Very bright, originally was going to use two, decided one was plenty. The photo doesn’t do it justice. Good buy!

They work ok, decent amount of light but don't project as far as I would prefer- mostly down and not more than 50 feet in front of door but amount of light is good. The glass lenses is great and the swing hinges are a good idea but the reason they are needed is because the wiring is done from inside the light not the back and requires removal of a reflecting lens which is very fragile, removal of screws and hanging these components by attached cables while doing this 18 feet in the air. One of the cables snapped and handling the lens is tricky since it is flimsy and you don't want to touch it with fingers. Overall, a good purchase. One problem that has just appeared - one of them now shuts off at night, It will turn back on with the switch but then goes back out again as if the sensor is getting reflected light.

Bought these to replace two old burnt out fixtures on the front of my barn. While installing the first lamp, I discovered that the second lamp was only out because of a tripped breaker. The mounting point looks correct, but I drilled through the aluminum housing at the rear for holes to match the prior installation (thank goodness for aluminum and not steel or plastic!) Beyond that, installation was literally "fix to wall, connect wires, close fixture, enjoy!" I didn't end up replacing the other older fixture, but I'm contemplating mounting my "spare" fixture somewhere else. The flood light pattern is great. Highly recommend.

the lens is glass and the body is cast aluminum with conduit connections on the back, left, right, and top when looking at the front of the light. the back also has a round junction box mounting that needs to be drilled. the photo cell is on the lift side next to the conduit hole. comes with cover to disable, but i find it easier to just disconnect the sensor all together. however if you are switching to using it and not, best to utilize the cover. the light is able to be dimmed with a 0-10v signal. you do have to remove the interior reflector to get to the wiring but at least it utilizes the same philips head screw that you need to remove the cover. no extra tools.

These lights are well built with solid metal.....not flimsy plastic crap. These are a nice pair that bring plenty of light and once intalled should last for many years. Good quality, strong, rugged and nice looking. Installation is not super easy but its not impossible either. Overall i'm pleased with these lights.