YOOPAI 3D Printer Enclosure with LED Lighting, Fireproof Dustproof Tent Constant Temperature Protective Cover for Creality Ender 3/Ender 3 Pro/Ender 3V2/Ender 3S1/Neo/Anycubic Elegoo, 28.7×25.6×21.6"

Easy to put together, seems to stop draughts and retain heat quite well. The opening is big enough to lift an ender 3 in and out with little issue. Could possibly do with not being as deep but my guess it is as such to accommodate different size printers. It's withheld a few months work without issue. I got the enclosure with the LED light and this is surprisingly lights quite bright. Probably helped by the fire retardant coating on the inside of the enclosure. Oh and it is incredibly lightweight.

I've been meaning to get an enclosure for ages, as my printer sits near an HVAC vent and I know that doesn't help prints. Temps vary wildly in the basement too, and I'm sure that isn't helping. Finally pulled the trigger on this enclosure. The medium size is HUGE and has more than enough room for my Ender3 Pro. Assembly was straightforward, and didn't take too much effort. Directions were good. Just make sure you fully seat all of the rods into their sockets and you shouldn't have any issues. I found it easy to assemble the frame and set it on the floor, then slide the the cover over the frame, versus the directions saying to try to drop the frame into the loose cover. It's a snug fit, but it went on with no problem. I was able to zip-tie my webcam to the frame, so it didn't need to sit on the stand that I printed for it anymore, which is a nice space saver. I need to clean up some wires and make things look nice inside, but it's a great enclosure that should help me get more clean and consistent prints. It also cut the fan and printer noise way down, which is great! My only small complaint would be the light bar - it puts out enough light in there to work, but I feel like no matter where I've tried to move it, it's just not quite right with my webcam and Klipper. I see they sell additional lights, so I may buy one, or just design and print some other kind of solution. Other than that one small thing, which isn't worth knocking the product, as it's a personal preference, this enclosure rocks!

Per quanto costa è un upgrade alla stampante 3d incredibile, non ho più avuto alcun problema di warping e fallimenti di stampa da quando la uso, ho iniziato anche a stampare ASA e abs con un estrattore in garage e ha dato nuova vita a una stampante che non usavo più.

Easy to setup for my Egeloo printer. Supports appeared strong,cover fit very well. No gaps or rough corners. Cables easy to work with through the cover sides. Reflective interior keeps temp stable. LED light works well. A good purchase!

Lo recomiendo al 100/100 muy buena calidad y se monta muy rápido mi impresora es una bambú lab a1 y entra en el armario perfectamente rine si espacio de sombra lo recuerdo 😊