RPi Raspberry Pi 2 Pi 3 A+ B+ Proto Breadboard PCB Prototyping Board (3 Pack)

This is a good board. I use it on a Particle Muon and M1E enclosure that has the Pi 40-pin header. Functionality and fit are great. Its a good value for someone that want to mock up before pcb manufacture

Very useful and handy. Plenty of bus lines for 3.3v 5v and ground. I was also easily able to solder to the board. Great product for the Pi lover.

This kit is the best deal for a Raspberry Pi 3 kit that I found. I like the case better than another brand that I have. It's nice to be able to see the LEDs through the clear case. However, the SD card that came with it was bad and I wasted a lot of time on confusing problems until I replaced the card. Now everything is fine and the Pi is a dedicated VPN server.

Pros: * Raspberry Pi 3 is great and standard * Heatsinks are easy to apply * HDMI cable is pretty standard * Power cable is AMAZING due to its on/off toggle (the pi doesn't have a power on/off by default * USB adapter for microSD card is very helpful for setting things up Cons: * The case is very tight around the microSD slot * No instructions (most of it is fairly obvious, but still...) So in setting up the raspberry pi, you might need to move the microSD card back and forth from your computer to install operating systems or edit configurations. If your pi is in the case, then it is VERY difficult to remove the microSD card. The opening is very narrow - meaning it is basically impossible to reach in with your fingers to remove it. I wasn't even able to get my needle-nose pliers in there to remove it. Luckily, I found that you can take rather sticky tape and place that on the card to be able to pull it out with the tape. While the case design made it difficult - I had a workaround, so I wasn't too put off. And knowing that the case makes it difficult, I removed my pi from the case so until I knew I was done moving the SD card. After a few more configuration changes, I'm finally ready and I attempt to put my pi back into the case. Little did I know that you CANNOT put the pi in the case while the microSD card is in. Attempting to do so cracked the microSD card. So now I need another microSD card due to the poorly designed case. Bleh. Everything else is pretty good though. But perhaps look for a different case.

I really liked the layout of the prototyping area on the board which allowed me to add a fan in one corner and solder in the connectors to support connecting my Rpi 4B to my RC receiver so I can drive my Donkey Car with my RC transmitter.

- quality is good - i would buy another one - using the pi hat to hold a RTC and shutdown btn and restart btn - with a tiny mod it will fit into a canada raspberry pi kit transparent case (have to remove an 1/8 of inch pcb along a 1 inch strip...i used a drill press with a small grinder bit, it took 2 minutes)

Love the different buss configurations. great mounting options for IC chips and other non standard ICs. Well marked. Fit my Pi 3 and 4. Robust solder pads....allowed me to solder and unsolder without damaging the pad or through hole.

I want to like this board but there are some issues. The pin soder points have no shielding which caused me a short that wrecked a Rasperry Pi. Port directionally would have been nice. I did like the double sided soder points which were quite sturdy.

This board worked very well for my PiKVM project. I was able to construct the ATX controller with no difficulty and the layout worked great, clean and simple. The IO pins were all nicely labeled which made the connections easy to make. Soldering was a little finicky if you have not worked with small components before so be warned, you need a steady hand and good eyesight. I highly recommend this board, and I should also mention that it is compatible with Pi 4.

Loved how well laid out the board was. It fit every thing I needed with room to spare.

As advertised

Bonne qualité