SATA to USB Enclosure

I have a drive case have been using for years and years and years, and it had an external cable that plugged into a port on the drive. I went to pick it up the other day, and the port had seperated from the board inside. I am thinking it is probably my fault from carrying it in my bag while leaving the cable plugged in. So, I couldn't access the files on the drive anymore. I needed a new case. But cases, and cables, and ports, have changed a bit since I got my last one. I have also embraced USB C and I have worked on simplifying my life by trying to normalize on the one standard to minimize the cables I need.I seemed to have three choices.A case like I had with a micro B connectorA case with a USB C connectorA case with an integrated connector (like this one)I was torn between the last two optiones, and it really came down to BENFEI, because they had two cases, each the exact same price, one with an integrated cable, and one with a seperate cable.I thought about getting the one with the seperate cable becauseIf you need a cable of a different length, you just swap it outIf your cable breaks, you just swap it outIf you have multiple USB C devices, you don't need multiple cables, so potentially less clutter.In the end, I chose to get the integrated cable anyway because, I know myself, and I know, I tend to leave the cable plugged in anyway. That is actually why I need a new case.They are so cheap anyway. A good cable will cost almost as much as the whole enclosure. If the cable breaks, I can just get a new one.This had an integrated converter, so I can plug it into an old computer that doesn't have USB C, but when in USB A mode, you can't even tell hardly there is a converter.last but not least, I was just at a place where someone had a case just like my old one with the micro usb B case, and they were frantically looking around for their cable, and they couldn't find one. That will never happen with this case, since the cable cannot be removed.The downside is, the cable can't be removed, so makes it a little harder maybe to pack into a bag. The length is still a potential issue, but I do also carry with me a USB C extension cable, so if I need more length, I can just use that.How is the case? Well, It is quite nice actually. The fit was quite snug actually. there were some little foam fillers on the sides and at first I thought maybe I had gotten the wrong case, because it almost didn't seem the drive was going to fit in, but it did, and it is nice and snug, and small and compact, and for all of the reasons listed above, I really quite like it. I quite like the beveled adges all around the case too. I have access to my files again. It works fine.I mean, as affordable as all of these cases seem to be now, I may even pick up a few more for other old drives I have laying around so I don't have to swap them out.

simple and reliable way to turn an internal drive into portable storage. The tool-free design makes installation quick and hassle-free, which is especially convenient for people who want an easy setup without dealing with screws or complicated steps. It feels practical for backups, file transfers, or repurposing an old 2.5-inch SATA drive, and the USB connection adds everyday convenience. Overall, it’s a user-friendly, efficient, and great-value enclosure for both occasional and regular use.

This external hard drive enclosure worked perfectly for what I needed. I used it to recover files and old personal photos from a laptop hard drive, and the setup process was incredibly simple.I really liked that it’s tool-free, which made installation fast and convenient. The drive fit securely inside and my computer recognized it immediately without any issues.Transfer speeds were good and the connection felt stable during long file transfers. The enclosure itself feels lightweight but solid, and it has worked reliably every time I’ve used it.👍 Pros✔ Easy tool-free installation✔ Stable connection✔ Good transfer speeds✔ Great for recovering old files✔ Lightweight and practical design⭐ Final thoughtsIf you need a simple and reliable way to access or recover files from an old hard drive, this enclosure is an excellent option. Very easy to use and worked exactly as expected.

Fits snug and drive does not shift around inside enclosure. The fact it has USB c gives me options of what I can connect it to easily. Installing the drive is a little tight so do not rush it and wiggle it in as my 4tb corsair drive is very tightly secured inside it.

Really works well and the USB-A and C connections are a really useful feature! Well worth the money!

Works great, assembles easily. Plenty fast and good price.

The product arrived well protected, with clean, undamaged packaging. Upon opening it, I was surprised by how compact and lightweight it is, and the black plastic design feels solid and well made.I've been using it for a few days, connecting it to 2.5-inch SSDs and HDDs, and everything works without a hitch. Thanks to UASP SATA III support, transfers reach up to 5 Gbps, which is noticeably faster about 70% faster than traditional USB 3.0. Tool-free installation was very simple: just slide the cover, insert the drive, close it, and you're done.What stands out most is the dual USB-C and USB-A compatibility: I don't have to search for different adapters depending on the device. Its versatility is also excellent: it works with Windows, macOS, Linux, and even consoles like the PS4, and accepts drives up to 6 TB and 9.5 mm thick.Overall, I think it's an excellent purchase. It's ideal for anyone who needs to expand or reuse drives quickly and efficiently—especially for those who frequently move large files. I would especially recommend it to students, professionals, or gamers. I would definitely buy it again.

Got this to add an external SSD to an HP All-In-One that only has one HDD drive bay - which has been upgraded to a SSD. I'm mainly using it for Quickbooks Desktop backups. I tried using a thumb drive but QB would literally take 10 minutes or more to "finalize" the backup and fininsh, allowing use of the QB software again. Everything worked fine but I have no idea why the delay. It would get to about 90% and just lag. So I plugged in an extra SSD from an old laptop into a HDD utility box that uses a power chord and cables to connect an uninstalled HDD or SSD to a USB port. It worked fine with QB backup so I bought this case to make the connection less messy and more permanent.The case is very basic with a sliding cover and internal SATA connection. It's a tight fit for the SSD but that keeps it from moving around. It comes with 2 felt pads that you can install on the cover to hold the SSD more firmly in place but I decided not to use them. One pad is 1.5mm thick and the other is 3mm.The chord has both a USB-A and USB-C convertible end - the USB-C plugs in to the USB-A, or you can use the USB-C by itself. I'm using the USB-A connection.After installation and plugging it into a USB port the unit powers on and is immediately available for use.The instructions say to initialize and partition the SSD before use if brand new, but mine was already set to go. I need a magnifying glass to read the instructions, but they are clear and easily followed. It says after 10 minutes the device goes into "smart sleep mode" and powers down the SSD to save energy and preserve the life of the SSD. I'm not sure if this actually happens on my system because the power light stays lit on the box continually.Overall this is a sturdy case that firmly holds the SSD in place and functions well when plugged in to the USB port. Recommended.

I set this enclosure up today and I’m really impressed. It’s simple, affordable, and works exactly the way a tech like me expects. The design is solid and it even comes with foam pads — one for SSDs and one for HDDs — so your drive fits snug and secure. I’m using it with a SanDisk SSD and the foam pad keeps it perfectly in place with no wiggle.The built-in USB cable is a great touch because I can’t misplace it, and it connects at full speed with no issues. I tested it with games and it loads them fast, just like running on an internal drive.This isn’t some flashy, overpriced gadget — it’s reliable, practical, and does the job right. If you want a no-nonsense enclosure for 2.5” SSDs or HDDs, this is a 5-star product all the way.

Boitier pour disque dur de taille 2.5 pouces. Facile à ouvrir et accepte les disques durs de plus de 7mm d'épaisseur. Au besoin, pour les SSD fins sont fournis des pads qui permettent de caler le disque dans son emplacement. Le cordon est solide et la prise USB 3.0 pratique et peut également être utilisé sur les PC ayant de l'USB-C avec une vitesse de transfert plus élevée. Je recommande! j'en suis à mon troisième boitier.

Ich habe das BENFEI 2,5-Zoll-Festplattengehäuse gekauft, um eine ausgediente SATA-SSD als externe Festplatte weiterzuverwenden. Nach mehreren Wochen Nutzung bin ich insgesamt sehr zufrieden. Das Gehäuse überzeugt durch eine einfache Installation, eine gute Verarbeitung und eine zuverlässige Datenübertragung.Bereits beim Auspacken macht das Gehäuse einen hochwertigen Eindruck. Es wirkt stabil, sauber verarbeitet und gleichzeitig angenehm kompakt. Dadurch eignet es sich hervorragend für den mobilen Einsatz und passt problemlos in jede Laptop- oder Zubehörtasche.Der Einbau der SSD verlief unkompliziert. Das Laufwerk ließ sich ohne großen Aufwand einsetzen und wurde sofort korrekt erkannt. Besonders praktisch ist, dass für die Montage in der Regel kein zusätzliches Werkzeug benötigt wird. Innerhalb weniger Minuten war das Gehäuse einsatzbereit.Positiv hervorzuheben ist die Unterstützung von USB-C 3.2 Gen 2 sowie SATA III mit bis zu 6 Gbit/s. In Verbindung mit einer schnellen SSD werden Daten zügig übertragen. Große Dateien, Fotos oder Videos lassen sich deutlich schneller kopieren als mit älteren USB-Standards. Die tatsächliche Geschwindigkeit hängt natürlich auch von der verwendeten SSD und dem jeweiligen Computer ab, insgesamt konnte ich aber sehr gute Übertragungsraten feststellen.Ebenfalls gelungen finde ich die Kompatibilität. Das Gehäuse funktionierte sowohl an einem USB-C-Anschluss als auch über USB-A problemlos. Dadurch lässt es sich flexibel an verschiedenen Computern und Notebooks verwenden, ohne zusätzliche Adapter kaufen zu müssen.Während längerer Datenübertragungen blieb das Gehäuse zuverlässig in Betrieb. Es erwärmt sich zwar leicht – was bei SSDs und schnellen USB-Verbindungen völlig normal ist –, jedoch nie in einem Bereich, der Anlass zur Sorge geben würde.Einen kleinen Punkt Abzug gibt es lediglich dafür, dass das Gehäuse bei häufigem mobilen Einsatz etwas empfindlich gegenüber Kratzern sein kann. Eine kleine Schutzhülle wäre daher eine sinnvolle Ergänzung, wenn man es regelmäßig transportiert. Auf die Funktion hat dies jedoch keinerlei Einfluss.Insgesamt bietet das BENFEI 2,5-Zoll-Festplattengehäuse eine gelungene Kombination aus einfacher Installation, schneller Datenübertragung und hochwertiger Verarbeitung. Es eignet sich hervorragend, um SATA-SSDs oder HDDs weiterzuverwenden und daraus eine leistungsfähige externe Festplatte zu machen. Das Preis-Leistungs-Verhältnis ist aus meiner Sicht sehr gut und ich kann das Gehäuse guten Gewissens weiterempfehlen.

Parfait, deux ports usb et usb c

Very Good product. East to connect SSD hard drive. Good Quality