UKEW 360° PIR Motion Sensor - Adjustable Recessed Occupancy Detector with Timer & LUX Control - Indoor Smart Presence Sensor for Lights, Hallways, Bathrooms & Utility Rooms

Having bathroom totally re modelled so decided to up lighting fixtures as well, looked at a number of these types of device and reading the reviews this one seemed good value for money. Arrived quickly and well packed, new lights installed pull switch removed. In the instructions it states 60mm hole, this felt a little light so opted for 64mm, which was a perfect match, went in easily and is not loose in fitting. One thing to be aware of is that this device needs a live an neutral as well as the loop to operate. Once wired in all was switched back on, slight pause, takes 30secs to set up, and let there be light. Sensor is great, light comes on as the door is opened and lights stay on while some one is moving inside. A little playing with timer now down to 2 mins, which means no more lights left on all day and now no daughter showering with out the fan being on, as also on the sensor. Perfect.

If you live in a house like mine where lights are left on all day/night then this is a real money saver. I fitted the switch into my sitting room light setup. I have 10 recessed lights operated by 2 switches, each turning on one circuit of 5 lights. I replaced the first light in the line with this detector so that when the switch is turned on the detector sits between it and the other lights. I have it set to the max duration so it doesn't go off every five minutes but I think that I am saving approx 5 hours/day x 5 lights worth of electricity (my family think nothing of heading out to school/work and leaving the lights on all day with no-one home). The ceiling height in the room is 16ft and the detector works easily when someone is in the room. You have to sit very still for the 15 mins or so of the timer before it will go off as once it detects movement it resets the timer to start again.

Got this as a replacement for our bathroom light sensor as the other one stopped working, easy to adjust the time settings - slightly smaller than anticipated for the gap but it’s fine. Works well, easy to install - overall happy.

I have just fitted this motion sensor in our bathroom to replace two previous Danlers sensors. Great that the ceiling hole size is exactly the same as the Danlers unit, so fitting was a straight swap, but at a third of the price. Much easier to set up as well which was a bonus. Strange that is described as being for use in a bathroom situation, but it is only IP20 rated - not a problem in my particular situation location wise, but I wouldn't use it in the vicinity of a shower enclosure or a steamy environment.

Very reliable PIR sensor for room occupancy. It can be adjusted for time and light sensitivity , and was just over half the price on a similar unit in my local electrical wholesalers . Easily wired in to lighting circuit ( by suitably trained person). So far, very impressed .

I bought this not quite knowing whether it would work as an override to a 2-way lighting circuit, but it seems to use a relay internally so there is no difficulty having the PIR output sometimes live from the load. It provides for wide variation in timing and sensitivity. Since I want a quick period of light as I move through the hall at night, it's fine on 10seconds and minimum Lux.

Being a tad old school and a little frugal, it irked me when visiting family tended always to leave the bathroom lights on but not with this little almost hidden little gem, works everytime.

A good motion sensor, looks good when fitted in the ceiling. The instructions suggest a 60mm hole, that is not big enough for the sensor to enter! I drilled a 70mm hole which was perfect and allows easy partial removal to adjust the time & lux settings. When lux is set to "Sun" the sensor switches on & off in daylight. This is what I wanted for a cloakroom with low ambient light. It works for me, recommended.