Engine Upper Radiator Coolant Water Hose Pipe For BMW,17127531579

No leaks, fits great, and feels just like an OEM part. Easy to install but be careful when you remove the old hose. If it fights you even a little bit, STOP, soak it with some PB blaster or WD-40, and take your time. Otherwise, you might crack your radiator’s side tank (like I did). Also, make sure all of the bits get removed with your old hose. There is a rubber o-ring and a chamfered ring in each fitting. They tend to stay on the radiator and/or engine inlet. Also, clean off all of the connecting surfaces before installing the new hose. A little coolant to lube the new o-rings never hurts either.

Good quality!!! Prefect fit!!!

Excelente

Excelente, le quedó perfecto a mi BMW 128i. Solo fue reemplazar la pieza vieja por esta

Replaced mine proactively when I was doing the water pump. It felt like it was short to begin with when I installed it. However it locked in, but did not last 6 months, started leaking at the oil filter housing. Made a mess so it is time for a reputable brand. Don't waste your money, time, or coolant etc...

I installed this hose on a E92 08 BMW 328i. My hose was barely leaking but when i tried to remove it it completely snapped off. The remaining plastic piece was stuck on the aluminum tube and had to be cut off. You will have to remove your air box to access the hose. If you have the factory clamp on the small hose just cut off the hose and use a new clamp. Make sure you clean the aluminum tube or else you will not get a good seal. The hose has grooves and will only go in 1 way so make sure you align the grooves. A little bit of grease on the ends allows it to slide right in. After you install it refill your coolant tank with coolant. The hose was very easy to install, it was shipped very fast. The price was the lowest anywhere. The plastic on the BMW factory hoses become brittle after time, if you are replacing 1 hose because of this you should check all your hoses. More than likely you will find other ones that will need to be replaced soon.

Great quality hose! fits right in OEM spot with no fuss or issue! in my opinion it looks and feels better quality then OEM, the one in my car had pinhole so i went looking everywhere! auto parts stores were crazy expensive and some had days to weeks of shipping time or drive a million miles to a sister store, found this cheaper then anywhere and shipping was fast and packaged well! put it on and solved my issue, fitment was perfect and never had an issue! if you're in need this is the one to go for!

It was a decent fit but was definitely longer then the original

Good product but it is too long for the n52, I was able to trim 2-3 inches off the hose part and re-clamp it onto the plastic connector. Had to use a dremel to cut the metal ring that holds the hose onto the plastic part.

Wrong angle. Hose is too short. Will have to use the old hose and cut the clamps off. If you’re wanting to go the cheap route then you will have to diy this to make yours work. I’d suggest save your time and buy the right one for a bit more.

Did not last 9 months on a car that did 2000km and was parked indoors in the winter.