Remote Starter Kit for Jeep Compass (2019, 2020, 2021, 2022, 2023, 2024, 2025) & Renegade (2018-2022) Vehicles | Push-to-Start Ignition | Plug & Play Install | Zero Wire Splicing

2023 Jeep compass. So far so good. Be sure to read the instructions thoroughly and watch both the videos. I started the night before installing the device by going onto the computer and downloading the KLON program and setting it up. The next morning I started the install. Be sure to follow the instructions carefully. I had it all installed and up and working within an hour. For the newer jeep models 22+ you dont have to open up the lower steering colomb. All you have to do is use the pry tool they provide to pop up the trim next to the start button. You dont have to take the whole trim off, just pop it up a little to be able to unhook the wire harness, and to run the new harness. Also, in yhe video it states that you hook it up to the wiring just above the gas pedal. That info is incorrect. The wiring harness is actually up above the brake pedal. Other than that. It was an easy install.

It works. My only problem I had was the video that instructed you HOW to hook it up. They said one of the plugs I needed to use was above the gas pedal. NOPE!!! And If you watch the video close you can see they go up and under the dash on the LEFT sided, slightly above the fuse box. Watch where they go with the camera. Other than that, it works great. I cannot stress enough that you follow the programming directions. It will NOT work if not programmed properly. It may take several times. It states this in the directions. Be patient and follow instructions exactly and you'll be fine. :-)

Caused so many more problems than it created solutions. Bad product that does not play nice with jeeps at least. Would recipe d to no one.

Outstanding performance

Fairly easy to install. Its helpful they have vehicle specific videos. Although the video for my vehicle had an error that was pointed out in numerous comments. The videos were short which was nice, but they could of been a little more informative. I emailed thier customer support. They wanted me to send them a video of me installing everything before they would help. I thought that was weird. I give it 4 stars because while it works. I have to hit the lock button 5 times instead of 3.

Bought it for a 25 compass , little difficult to find the security gateway module to install the T- harness, other than that it was easy to install and to program at the pc... this is the third one that I bought for my cars... the 3 of then, easy to install... thanks

Installation was pretty straightforward according to the directions. The only thing to be aware of is once you get to the section where the directions tell you to push the start button to on ( not start the vehicle) until the light on the control box flashes green it takes about 8-9 time doing it for a Renegade. I think the instructions could have a side note saying some vehicles may take doing this step up to 10 times but other than getting frustrated with this step in the programming process it works great and the wife is very happy she doesn't have to get into a cold Jeep now!

I reached out to the company and it was a process, no phone number just email. The tech support basically just read the instructions as they come in the manual. I’m not stupid I know how to read, long story short it didn’t work at all it wouldn’t flash green even after I flash the firmware on the module. I read the reviews and thought it would work but it didn’t for me. Proceed at your own risk

longest part of install was getting a log in to the website. Slick, only one fob. Push lock 3 times