Jonard Tools WBK-100 Panel Buddy Knockout Set for Front and Rear Knockouts

I am an electrician and was a little skeptical about this product. However I have now used it in the field and it works like a charm. Its a very clever device. Its also sturdy and well made.

I had to pop a knockout out in a panel in a tight spot, where I would otherwise cut a low voltage plate in, and and hammer the knockout out. I had a case, where I did not have clearance to do so. I used this on a Hubbell Network Enclosure panel in drywall, which barely had a gap around it. I had to jab a bigger gap, but the panel surround/door covered it right up. The tool worked without a hitch, and was almost easier than hammering the knockout out. I'd highly recommend this tool!

does what it is suppose to!!

Way better than a hammer and screwdriver, which often times loosens the outer nested ring.This is effortless and impactless. Keep them in my electrical bag and have used them several times on my home renovation so far.

Actually works. I was skeptical when I ordered it but it was surprisingly easy to remove knockdown from electrical box.

Great Idea and I made my own......Except I still had to cut the dry wall to put in the clamp for the wire.

This is a great product. It has performed well both times I needed it. What a fine idea.

After using the product for the first time, I was absolutely delighted. It made opening the knockout to a panel in a finished wall so easy. Wish I had gotten one years ago.

Great product

Works well, just need to be carefull using it