Cable Clips, Ethernet Cable Organizer, Conwork Adhesive Wire Management Clamps, Desktop Cord Holder Hider, Charging Cable Drop Organizer & Management System for TV PC Laptop Home Office [50-Pack]

We actually used these for the underside of a model train table set up to hold all of the wiring. They are very easy to use and stick well We used the whole package so have to order more but we recommend these for most any cable or wiring use. Good value especially when they work this well.

Honestly these are fantastic, very simple, but the fact they actually "lock" down the cables rather than just grip them like most cable management clips do is a major plus, it also makes them very easy to remove the cables when needed. They also easily hold multiple cables each, easily 3-5 cables depending on size. They are slightly too small for power-brick cables however, but then most cable grips are too small for those. Adhesive is fantastic on the 6 or so I've used so far, and feels like they can easily hold up several pounds in weight each. With exception to buying some larger ones for the thicker cables, I'll be using these almost exclusively from now on.

They do not hold smaller cables securely. Needs a glue-in (sticky back) spacer(s) that could compress the wires for small cables such as for iPad, iPhone charge cables.

These clips are great for tidying up cables but the adhesive is just ok. I ended up breaking out the super glue to adhere most of them and they've held up since.

As stated. PRO: This works for my needs, just barely. It is not overly expensive and that is also a benefit. If I only needed thin ethernet cords, this would be perfect for that type of application. I would say, in that case it would have been flawless. CON: Heavier cords such as surge protectors it pulls off the wall some, but in my case not all the way. I would rather the adhesive pull paint off the wall than have it come off cleanly. That adhesive is just not strong enough for my liking. It is separating because of a wire from a surge protector. As this was one of the primary purposes for purchase, this needs better glue.

I used these when installing a switch in my basement to keep Ethernet cabling clean, and secure. About 3 months later the adhesion is holding well. If you are using with CAT 6 I recommend no more than three cables per clip. Cat 5e I'd say maybe about five cables or so. Also, easy to open when adding / replacing cables. Definitely a good find, and something worth having on hand for a multitude of uses.

Proper binding post with hole in connector. Would just of soon had them in Red and Black bodies but these work. The vendor's lack of dimensional data makes it difficult to plan out a design using them. Thus I ordered a set to measure for a power supply I was working on.The hole in the panel needs to be 7mm. There is supposed to be a picture attached to this review with the dimensions ... if it ain't here then .... UPDATE (May 2020): These work excellent as 'Binding Posts' however they can NOT b used with ‘safety-sheathed’ banana plugs. To be fair I have not found any source for panel jacks that are decent 'binding posts' as well as supporting ‘safety-sheathed’ banana plugs. They must exist because I have a power supply that is equiped with them.

Used these under a desk to guild various small cables and keep them in an orderly fashion. The surface was smoth finshed wood which should be an optimal surface for adhesives to maintain a bond. They all fell off after 6 months of being installed. The slight weight of the cables eventually pulled them off. These are small USB cables. These might work better as guides and for non-weight bearing applications.

very good service and product

This product works as advertised berry good guality

Pay attention to package bought a dual set four in total thinking this was one unit and not for a pair my mistake.

I had to drill out the existing holes on the speaker circuit board to make the replacement connectors fit. If you are not handy, you’re in trouble

bonne qualité.👍😊