2 Pack 1/2" G (BSP) Female Thread to US 1/2" NPT Male Thread Pipe Fitting,Brass Pipe Fitting Adapter,G to NPT Adapter 1/2 Inch

These adaptors work very well. The threads are deep enough and long enough to make good, solid connections. And they look good, too.

When I got it, I charged it and it wouldn't work. the punp would run for a few seconds and quit. I opened the middle where the stainless tube screws onto the plastic handle of it and found the check valve was upside down. I flipped it, it fell into position, the pressure from the pump locked it into place. Easy as changing batteries in an old flashlight. And now it works great! It has quite a kick to it, about like a .22 rifle. It was an easy fix, no tools required

This adapter saved my sanity, thanks! It was the only way to install a nice shower in an old house down in Colombia

I bought these because I needed to convert a BPS thread to NPT threads. It is hard to tell the difference in pitch of the threads and I have read quite a bit on the differences to realize they are different and may cause leaks due to the small differences in the pitch diameter of the threads. These worked perfect for my application on a BPS 1/2-in faucet I bought overseas for use with other US fittings in a place that I did not want any leaks. After a couple of months of being installed, no leaks and I don't expect any. These worked perfect for my application.

worked to get my Japanese shower head to connect to my US shower cord.

These look & feel sturdy & machined thick to handle psi... unfortunately, I returned these due to change of plans in my project design... thank you

Just what I needed for my solar Panel

The recirculating pump I bought on this site had BSP fittings (so annoying) so I needed something to convert it to NPT. This did the trick perfectly. Just be careful how tight you tighten down on the rubber gaskets with your fitting to make sure they get a good seal and use plenty of teflon tape/pipe dope.

This fitting is not NPT male it's 3/4 BSP female to 3/4 BSP male useless to fit to a NPT fitting, very misleading

Great adapters. Works for what I needed it for, Threads are precision cut! Recommend

bueno, medidas exactas, solo hay que reforzar con cinta teflón, es muy difícil encontrar este tipo de adaptadores en México, gracias.

Solid Metal No Burrs or anything but it was too deep for my male thread had to use 2 seal rings to make decent t contact.

This is meant to be 2 Pack G 3/4 ( BSP ) Female Thread to US 3/4 NPT Male Thread Pipe Fitting. That is, the male is meant to be US 3/4 NPT and the female 3/4 BSP. I bought a 2 pack. If it was a BSP to NPT adapter, they would get about 1 1/2 threads in then begin to cross-thread. Yet, the adapter screwed all the way down to rubber gasket. When I went to attach the supposed 3/4 BSP Female end to a 3/4 BSP male fitting - it got about 1 1/2 threads then jammed. It's not 3/4 BSP female. It's pretty well much that simple.