YOUSHARES Table Mount Clamp for Mic - Boom Arm Clamp for Microphone Arm Stand with Adjustable Screw, the Maximum Gap is 6cm/2.36 inch

Stock arm mount broke, Bought this to replace it, Much easier on the table and more stable

The plastic base broke 9 months in.

Rock solid and sturdy. It takes up about two square inches on the edge of my desk. Quite pleased.

good!

Slim clamp allows for easy fitment between your desk and the wall. This only lasted for a few months before it broke apart on me. Looks like the plastic fatigued; would have easily paid more for it all being metal up top and not just the clamp portion.

Seller claims 1.2cm diameter but a 1cm diameter boom arm couldn’t fit inside. do not purchase if you have a RØDE boom arm

Great replacement and like that there's no screw in and swivels freely.

I purchased this new clamp to use with my InnoGear boom arm hoping for more stability. The clamp that came with my InnoGear is a nice clamp, it feels solid but is obviously just a very hard plastic mold with the bolt of the boom arm positioned off of the edge of where it is attached. This was not ideal for my setup as my end table is not solid wood and I was absolutely destroying the underside of it whenever I moved the arm due to all of the leverage being over a very small surface area. This is where I purchased this new clamp. It looked nice enough, moved the point of tension from off the side of the table to directly above where the C-clamp actually attaches, and has a wider base. My first problem came with the opening where the boom arm seats. Being only 0.47in wide the base of my InnoGear did not want to seat properly inside of it. Nothing that a 1/2" drill bit couldn't fix, I just took out a bit of the plastic molding from inside of the well so that my boom arm could seat nice and snug inside. I went to move it as a test and things went great. It no longer felt like I was going to tear a chunk out of my end table and I was able to move my boom arm very nicely. I attached my microphone and went to position the boom arm when something snapped and my boom arm and microphone fell to the ground. I thought I had torn my end table, but it turns out that the plastic of the base of this clamp actually snapped from the tension. I would still say that this is a step up for many microphone boom arms, but not larger boom arms. It is certainly sturdier than what most come with, but if you are attaching a larger boom arm for extra reach and then putting a 2lb microphone on the end of that, it will snap the plastic very easily.

tiene un buen diseño pero el material es de plástico y no resiste pesos de micrófonos profesionales de mas 1kg porque es susceptible a romperse