Magpul MAG003 Original Mag Assist

Bought these mostly to ensure my mags looked different than others. These worked perfect and look great. They are super tight to get on, but it's not impossible and didn't require and soap or lube, but it was tough! Totally worth the cost and it's a pretty comfortable way to get a grip on the bottom of the mag.

Tite fit hold goo

I've used these before on 10rnd AR 10 mag's and I knew what I was getting into installing these on my MP5 mag's. That said, I forgot how much of a pain in the ass these are to fit. I didn't use any tools and it's about 5 min install (x6). It's slightly over priced IMO for what it is, but it does improve retrieval and handling. I also like that it aids in both protecting mags when dropped and the finish of my firearm when wearing kit. If you have the patience to install it's a great relatively inexpensive upgrade at minimal weight increases.

Looks awesome on my B&T GHM9 magazines and works well pulling them out of the magazine carrier. Solid piece of kit if this is what you need for your subgun.

Tight fit. Use an actual commercial grade heat gun to soften up the rubber enough to slide it on the mag nice and easy and it's perfect.

I use these on my colt mag AR9 carbine so I can drop the mags without worrying about damaging them. They fit tight, actually look good, and the rubber material is easier to hold on to than the magazine's finish.

Difficult to get on. Had to use the hairdryer to get it warm enough to be playable

The original Magpul. Can’t go wrong with these