Angle grinder dust collection attachment for Double-Cut Saw,Wall Chaser dust shroud 5 inch AG03

This works great. It fits over my Hitachi/Metabo (the green brand) angle grinder no problem and it comes with an adjustable rubber connector to make sure your 1 1/4" shop vacuum can attach. I used this when taking down old plaster and it cut down the dust by at least 90%. You NEED this if you plan on cutting into any kind of cementitious material (concrete, plaster, drywall, mortar, etc.). Very good value for money and the piece of mind that you aren't getting dust everywhere. You still must wear a respirator though, it doesn't remove all dust, that's impossible. I've been using mine for two years and its still like new.

Good quality

Used it with Makita 9” diamond blade to cut through tile, cement, and rebar to take out walls and make windows. Made working conditions a breeze by eliminating the majority of dust from the cuts. Would definitely buy again.

I loved this shroud. It works perfectly! HOWEVER… if you are using it to cut concrete you should get an actual concrete saw. Because without water your blade will only cut 8 inches before overheating. But cutting with water totally negates the dust management System and gums up the entire thing. In conclusion it does what’s it’s supposed to very well. But is actually useless for any extensive masonry or concrete

It works! A few minutes to figure out which adapter collar my Milwaukee 4.5" angle grinder took, add the supplied spacer to put the blade more in the center of the collector, then adapt your shop vac to it and cut! I was cutting floor tiles to clear the way for wall sole plates for a new pantry and my wife made it very clear that she did not want to be cleaning the house of dust in every nick and crevice. While some dust does get away, it is minuscule and over 95-98% ends up in my shop-vac with a HEPA filter bag in it! * From the pictures you can see that my Milwaukee 4.5" angle grinder took a red spacer with the flange. You want to make sure that the shroud fits good and tight as if it doesn't it will come while cutting and that will be a big mess! * Don't forget the supplied spacer to keep the blade more centered. Just note that on mine, I had to take out the little bronze washer that came with my diamond blade as it caused the blade to spin loosely. Just make sure that the blade is sandwiched tightly between the backer / spacer assembly and the spanner nut. * While cutting make sure that you have locked the depth flange to the correct cut depth (the metal part with the black fastening nut) and have it make complete contact with the floor! When that minuscule amount of dust does leak it is not from the round hole on the side (leave it open for air intake to create the air flow needed), but from the bottom if you tilt it and thereby have the depth flange not flat with the floor! Overall, this was a great purchase and I highly recommend it. It works!