Sprayer For Grohe Pull Out Faucets

Much better price than the genuine Grohe replacement faucet. Works great and actually might be better than the original Grohe faucet. How? I like that when you switch from the single stream to the power stream, and then turn off the faucet and then turn it back on, it doesn't automatically go back to the single stream. You have to switch it back from the power stream to the single stream. Maybe some like the automatic feature of the original faucet, but we're all buying this faucet because the original faucet from Grohe eventually went bad, and it's possible that it went bad because of that design feature. I'm not sure of my theory, but what I am sure of, is this replacement faucet is cheaper than the original Grohe faucet, and it's cheaper than buying and installing a brand new faucet. And this comes with some new o-rings. It also fits like a glove over the original faucet end.

The product came with a perfectly good O-ring and a (removable) flow restrictor. I left the flow restrictor in place. The comments which said you have to buy an O-ring are incorrect. I wasted nine bucks on O-rings which I don't need. (Too much trouble to return them.) As recommended by other commenters, I coated the new O-ring with plumber's grease. The new faucet head installed very easily, just using a pair of pliers to grasp the metal cuff which is part of the hose; unscrew the old faucet head and screw on the new one. The new faucet is working perfectly after installation. Water pressure is fine; aerator and spray are working perfectly. No leaks. If I run into any problems later on, I'll update the review.

Works as required

The pull-out spray head is a replacement for my Grohe kitchen faucet. The spray head is exactly what I needed, easy to install, works great. The only problem with the product is that it does not have a snug fit when it is pushed back into the Curve of the original faucet (the spray head is pulled out/put back in). The bottom (diameter) is smaller than my original spray head. (The original spray head locks into the Curve of the faucet.)

Update 11/2/2023: After a few months it Stopped Working! Very Disappointed! ____________________ I just received the part. It was pretty easy to change out and I’m a senior woman with arthritic hands. There weren’t instructions so I looked on YouTube. Not much guidance. It does hand screw off and hand screw back on. Couldn’t find video that says where to place the o rings. It did not look like there were any old rings. (I guess they completely wore out.) So I 1st seated the larger ring on the end cap of the hose and next seated the smaller ring at the same end. Then I placed the new sprayer head against the end cap of the hose. Slid up the piece that screws it all back together. It did not leak....so far. I did remove the reducer as I live where the city water is especially hard. (I believe the reducer would be clogged in no time based on my hard water.) This replacement sprayer head works better than the original Grohe sprayer head. Only time will tell. I wish I replaced it sooner:-)

Update 4/27/2023: In less than 12 hours Awelife had a new replacement spray wand and o-rings delivered to my door! That is AWESOME service. Be sure to replace the existing o-ring on the hose with the properly sized new one provided by Awelife. See my photos for the broken wand and the new replacement I received. UPDATE 4/26/23: The spay wand continued to leak periodically. Today I retightened the wand to the hose. The wand broke apart. I always hand tightened the wand, never used tools. I am always careful about over tightening. Take care tightening. Got just over 8 months of use. Contacted the seller today... We'll see. The original spray wands of this model usually fail because of a very inexpensive degraded proprietary washer inside the unit. I took 2 of these wands apart and each time it was the same failed washer. I called Grohe and asked to buy a replacement washer. They said they don't sell them. I would have to purchase a VERY EXPENSIVE replacement wand. I asked about the lifetime warranty. They said I would need to produce the original invoice with my name on it. I bought it over 20 years ago! I didn't know where the invoice was. I lived with the malfunction for a long time. Then I found this replacement! It works and looks great! I would have to buy 10 of these replacement wants to equal the cost of one OEM replacement. As far as leaking. Mine also had a slight leak where the hose connects to the wand when I pulled the wand out. I suggest making sure the O-rings are correctly seated and tightening the wand firmly into the hose. That worked for me.

Needed a washer, but otherwise it fit perfectly and works wonderfully!

looks great . Not as good as the GROHE original but not bad. Works well with no leaks . Stream doesnt reset to default stream like original