110V 22mm LED Industrial Indicator Pilot Light Green 2-Pack

The media could not be loaded.  This light worked perfect for the purpose of knowing electric power was available to my septic system and pump. Installed easily into a electric junction box.

This light fit right into a knock out port on a junction box which is exactly what I needed. You will need to supply wires to install it, I used 18 gauge, but once installed it works as stated. This light is very bright; I have it set up with a solar hot water relay pump in my garage and when the pump comes on the light goes on. Since the pump is extremely quiet this light lets me know when it is on.

Needed a BRIGHT indicator light that was easy to see at a distance in daylight. This works to perfection in that regard. Sadly, the lamp I installed burned out in only 5 months. Perhaps that's why they're sold in packs of two? I expect an LED lamp to last AT LEAST as long as an incandecesnt lamp would, and definately they should last longer. So, it's bright all right, but durability is unacceptable.

The size of these indicators is bigger than the picture. The hole they fit into is .75 inch, The top is 1 inch diameter, they entire unit is 2 inches long. Once installed you won't be able to miss when they are lit.

I bought it to indicate when the furnace in my workshop is turned on. I couldn't believe the quality for the price.

They are very nice products at a good price.

The light is bright and easy to install, however it didn't even last 1 year before it went dark.Very disappointed!! Light #2 lasted less than 2 months. Absolute Junk!

Very good

perfect size. like the color. easy screw in wire contacts.

This 110 VAC LED pilot light is exactly as described, and is excellent value for the cost. A few comments:- it is very bright, and easy to see over a wide range of angles at considerable distance- it is designed to be mounted into a standard 7/8" diameter junction box knockout hole- recessed screw terminals are provided. These terminal screws are relatively small and not very robust - I would suggest using a segment of wire no larger than 18 gauge to connect this pilot light, and take care when tightening the screwUpdate April 2020 - first one I installed has failed after 3 months of usage. Second one has now been installed to replace it.

I added this to a dryer booster fan to show that the pressure sensor switch is activating properly. Mounts nicely in a 7/8" diameter hole.

Meets my needs, wanted something to show when heating element turned on with home built controller. Listed specs accurate. Price was reasonable, I'm sure I could have got cheaper direct from Asia but would've waited too long. Happy with it.

Worked exactly as expected, great little led indicator light