1155200 JK 2IN FRONT 1IN REAR BOOST/LEVELING KIT (INCLUDES FRONT SWAYBAR LINKS)

Buen kit de elevación, fácil de instalar uno mismo. Mejoró la altura del jeep de acuerdo a lo que deseaba, muy recomendable para quien no desea una conversión extrema.

I'll start by saying we're in the early stages of this Jeep build (2017 JKU Rubicon Recon); as my teenage daughter's skills and comfort increase so will the level of modifications to the Jeep. I've built 5 Jeeps previously and have used Teraflex components for all of them; I trust their quality above all others and appreciate the consideration they've taken to design, test, and support great products. This leveling kit increases the overall height of the Jeep by raising the front 2" and the rear 1" by placing spacers between the coil springs and their mounting buckets on the chassis. The intent of this deliberate difference in lift between the front and the rear is to "level" the Jeep, reducing the "nose low" factory stance. NOTE: after installation the Jeep is still about 1/4" taller in the rear with the factory soft top, and is exactly level with the factory hard top installed. Installation is extremely easy, and the supplied instructions are thorough, concise, and easy to follow. Start to finish installing this lift kit took me 2 hours and 15 minutes working alone with hand tools. The instructions detail which size wrenches and sockets you'll need, so be sure to read through them before starting the job in case there are any you don't have handy, but no special tools (spring compressors, etc.) are needed. You will need a small tube of "Red" thread locking compound for the front driveshaft flange bolts. Post installation experience: after the first day or two of driving, take a few minutes to check the tightness and torque of all suspension bolts involved in the install, especially the axle end of each track bar (those are the highest stress component of the suspension and tend to need a re-tourquing after the first couple hundred miles). With over 6,000 miles including a round trip from WI to FL and back, and two trail rides since the install, there have been no squeaks, rattles, or issues. On road the ride is just as smooth and predictable as ever so there was no appreciable difference even at interstate speeds. Off road the wheel travel increased enough to allow use of 285/75/17 tires (34" tall, 10.75" wide) with no clearance problems even at full articulation and full wheel turn. One thing to keep in mind; with the "leveling" of the overall vehicle stance, there is noticeably more hood buffering at highway speeds especially with a headwind (where the hood catches the wind and tries to "lift" against the hood retainers). This is a great entry level lift kit which will allow you to run a slightly larger tire, improve off road performance, and give your Jeep a more assertive appearance without breaking your bank or causing undesirable loss of ride comfort and handling.

There are a few tutorials online that make the install easy. Was done in 3 hours. No alignment was necessary and the jeep still handles great. Really happy with the new look.

The levelling kit was easy to instal. This adds approximately 2" on a two door Wrangler. It looks great and handles very well. I highly recommend.

Lift came on time and well packaged. Instructions could be better, but not bad if you have any auto mechanical knowledge. Recommend watching the install video on You-Tube. Put the lift on in about 3 hrs with basic tools. No impact gun, just wrenches, ratchets and sockets. Did it in my garage with a floor jack and 3 ton jack stands. Instructions and video say to disconnect front drive shaft. I felt this was an unnecessary step and did not do it. Springs came out easily and only problem I had was getting the driver side front spring back on, as it is the short side of the axle. To fix this problem, I used a bottle jack on passenger side to jack up the axle using the floor jack as the fulcrum point making the driver side drop down giving me plenty of room for the spring to be re-installed. The rear gave me ZERO problems. Video says to use grease on spacers for ease of installation, but I just used a light tap with a BFH and they popped right on. The ride is noticeably more stiff, which should be expected, but ride quality stayed the same with "STOCK" tires. Be aware that if aggressive mud tires are used, your ride will suffer. The front is level and the added lift looks great. Very pleased and would HIGHLY recommend this product. Edit: One thing I forgot to mention, the track bar. Did not line up after install, so I hooked a ratchet strap from axle to frame and used it to "ratchet" the track bar in place. Just an added step that took about 5 mins. I wasn't comfortable driving it forward to line it up. That's what (I) did, hope this helps you out.