DIN Rail Mounting Bracket | Rack Mount DIN Rail Kit Rack Ears DIN Rail Slotted Aluminum Alloy Oxidation Length 17 Inch Width 35mm Height 7.5mm

Din Rail bit flimsy but for price it's acceptable. Easy to put together and mount. No issues installing DIN components. Using this with their WTH-SG/RJ45 DIN-rail Mounted Gigabit Ethernet PoE Surge Protector .

A decent DIN rail to be sure. I just have a small 6-port PoE switch and a mini-PC mounted on it at the moment, but it could hold much more. I decided to try to mount a smaller sized mount to it to see if I could, just for the heck of it, and I ended up getting it stuck on it. To be clear, this was no fault of the rails and was all mine. All I can say is it was stuck on it quite firmly, and even though I was able to flex the rail some, it didn't deform at all while I man-handled it. I eventuially got the stuck mount off of there and inspected the rail and it was good as new. Definitely recommended and will buy again if the need arises.

I bought dozens of these for an engineerng project. They're made of extruded aluminum vs. stamped sheet metal, so they're less prone to bending an deformation when subjected to equipment loads. The offset mounts are useful.

I am very satisfied with product. However, the supplied M4 screws with washers are undersized and slip through rail slot. Installed rail with my own M5 screws/washers/split washer and very secure now.

It's a bit thin. It flexes with a device on it. This is the first DIN rail I have used that wasn't fastened to a backboard, so perhaps that's just the way they are, since they have to meet a standard thickness? I'd still buy it again for a light load. I have a Cisco IR1835 on it.

DIN rails make consolidation much easier than typical wiring solutions. With these I can minimize the electrical wiring needed to connect AC and DC components together on a single rail minimizing the total amount of space required.

simple, effective, and the rack tax isn't too bad compared to the alternatives

These DIN Rails have rack ears that fit a 19" equipment rack perfectly. The rail is also very sturdy and relays and other DIN devices snap on solidly and stay in place.

This was ok.

Buen material, aluminio anodizado, acero color negro, buena resistencia, cumple con el objetivo.