APIELE (Pack of 2) 22mm 3 Position Selector Switch Maintained 2NO XB2-20X/31 (3 Position Maintained)

I used these switched on a control panel I built for a milling machine VFD conversion. They are good quality, work well, and met all my expectations. I would say that I do prefer the switches with the quick release instead of this style which uses screws. I found during mockup the screws can be annoying, but that's only if you're working through a testing and tuning phase of a project. Once installed it's a non-issue.

These were the perfect switches to let me hook my RV solar panels to the house when the trailer is parked. With two strings of 8 panels each, this switch allows me to send the PV power to the RVs MPPT controller or directly to the MPPT and inverter located inside my house. Rather than letting my RV solar sit idle (it does that when the batteries are fully charged) it now gets inverted to shore power that the house consumes during the day.

I needed too add a switch too trun on a extra fuel pump, and glow plug control on a old woodchipper.. This worked great. bit of a pita too get installed iff you cant reach and hold front and back with both hands.. and the screws can be a pita if its a tight area.. I suggest wire it up, before you mount it.. BUT.. I had something short out, and wires actually melted together, but the switch was fine.. even with a bit larger wire now. and a better relay added.. it hasn't acted up.. I use one side ie (left) too turn on GLOW plugs-preheater on a diesel, then turn it too its 3rd position (right) too turn on the fuel lift pump, and everything else.. and middle position is OFF... Then with just a push button next too it too start/crank.. Its better then a bunch of uggly toggle switches.. and fits in the dash control that has big 3/4" holes nice..

These worked out perfectly for a Forward/Reverse selector on a drill press conversion to VFD. Only strange part was mounting. Ring does not tighten to face plate as normal, must use a set screw from behind to tighten. It worked out okay as long as you can access screw in your mounting position. Good price and arrived quickly.

Shipped on time, delivered on time, worked as expected. These switches are fantastic.

Well made. Drill a 7/8 inch hole (22mm) and tighten 2 screws on the back of the switch and it is held very securely.

they worked great. easy to wire. Very easy to disconnect the know, just pull the lever.

Works ass designed