Supershieldz (3 Pack) Designed for Microsoft Surface Duo Screen Protector, (3 Left Screen and 3 Right Screen) High Definition Clear Shield (PET)

Likes: 1) Price is right for 3 packs. 2) Easy to install, no bubbles! 3) Touch screen still works fine, allow Duo to fold 360. 4) Can install for inside and outside screen to protect scratches. Really has no complain, great product and work just fine. Not as heavy duty as a case but this allow my Duo to fold up easily. Not drop proof but does provide a better grip so less slippery. Price is fair, would definitely buy again if needed. Installation is pretty easy, used 2 sets for inside and outside and still has a set for spare!

First off, the product works fine. It's just like every other protector I've had for every other phone. It's tricky to get on right if you don't have a processor factory level clean room in your house, but it can be done. It hasn't affected my touch sensitivity at all. I actually left the 2nd protective layer on for a few minutes and that didn't even affect the touch. That brings me to pro tip number 1. Pro tip 1) As the instructions say, don't peel off layer 2 after attaching the protector. Leave it on so you can work out bubbles with the card/squeegee without scratching the protector. Even very large bubbles can usually be worked out with some effort and time but you don't want to put a bunch of marks in your new protector while doing it. Pro tip 2) Bubbles aren't necessarily a problem as long as you get it on straight. Dust is a problem. As I mentioned even large bubbled can usually be eliminated with patient use of the card or your finger nail. But if dust gets under it when you place it, that's not coming out ever. Pro tip 3) This one is specific just to the DUO. The left side screen protector can be applied to the outsides of your DUO to protect the outer glass from scratches it might get from normal use. In my opinion it's nearly invisible, barely affecting the look or feel of the device. It does have a tiny hole in one spot but that's difficult to even see. If you have a bumper, you may want to put these on the outside first. If not, you will have to cut one down for the side with the larger bumper. Enjoy your DUO scratch free inside and out.

I liked these screen protectors but I felt like the adhesive was a little weak. They come off just as easily as going on. Not sure how the company would make them stickier without compromising the safety of the phone though. They do protect against scratches. Easy to apply. It's like they want to jump on the phone when you get them close to the surface. Good buy for three shields. I had three chances to get it on there without bubbles.

These are straightforward plastic protective films and identical to the DMAX Armor films. Laser-cut, so with no bevel or rounded lip... it is just flat and precise. Full coverage, edge-to-edge. Feel slightly "tacky" compared to the bare Gorilla Glass used on the Duo, but not sticky. No touchscreen interference. The edges do collect some dust, but nothing gets underneath the film itself. Some notes to help you with application: 1. Buy 2-3 extra packs in case you mess up. Especially if you plan to use the full-screen notchless films to cover the outside faces of your device, too (the sizes match perfectly). 2. Wipe your screen with 91% isopropol and a microfiber cloth (see "Eco-fused" microfiber cloths here on Amazon). 3. Also wipe your protector with isopropol BEFORE you peel it apart. These films use static to cling to your device, and will re-attract any nearby dust particles. 4. A can of compressed air is a good final dust-off before you apply. 5. Peel off STEP 1 layer and place the film face-down on your device. STEP 2 layer gets peeled off at the end, to leave the exposed HD Clear film. 6. BEFORE you do #5, if you add a piece of folded Scotch-tape to STEP 2 layer, then you can have 2 finger tabs to grip while you correctly position the STEP 1 layer down. This helps tremendously for precise positioning. 7. Use the included card and microfiber to push out any remaining air bubbles. (But if the air bubbles contain a particle of dirt, it will not push-out.

I usually assume that the first (of 3 included) film will be wasted during my butterfinger attempts to align it dust and air pocket free on my screen... the fact that you can use a rolled strip of scotch tape to remove trapped dust was a break thru in achieving my first successful installation without wasting the first film... there are plenty of videos including the manufacturer's own that illustrate a good installation, I recommend you view as many of these as possible before attempting your first film application. Air pockets are easy to remove without having to lift up the film, and the scotch tape trick solves the trapped dust issue... I recommend this product especially if you plan on keeping your Duo folded backwards in your pocket.

Let’s face it. It is not easy to design any standard “phone protection accessory” for the Surface Duo. Other than Microsoft’s “Duo bumper” there’s no cases available for the Duo that provide the same kind of protection as for other phones. The Duo’s foldable design also seems to have limited our options for third-party screen protection. Too thick and the two screen protectors laying atop each other when the Duo is closed means the device won’t close fully — that thickness challenge also means no good quality tempered glass protectors. In the case of Supershieldz’s Screen Protector for the Surface Duo, you’re getting 3 very thin standard screen protectors per pack. Trust me, you’ll need all three as your first attempt will likely mess up. Why? Since these are so thin, most folks applying these will face the normal challenges of applying a screen protector (air bubbles and dust particles). In the case of this protector, since each panel is so very thin, there tend to be many more air bubbles than you’d have if this were a piece of tempered glass. In most cases, when you have bubbles, all you need is a soft plastic-edged squeegee or credit card to push the bubbles out to the end of the protector. This is where you’ll run into problems with the Supershieldz protector. First, because the protector is so thin, using too much force to push those bubbles out (especially the tiny ones) can leave faint scratches on the film (not at all ideal). Also, if you push too many bubbles out at the same point of the edge of the protector, it will weaken that area and, I think, over time (as a couple other reviews mentioned) will mean the protector film will “lift up” at those edges. The other challenge you’ll have is if dust particles are trapped under the film. In the case of a tempered glass protector, this is relatively easy - just take two pieces of clear tape, use one to lift up the protector, then dab at the screen or the rear of the protector where you think the dust particle is sitting, then re-apply the protector and make sure that particle is gone. That’s a little harder with a film protector, you have to peel up the edge in a way that doesn’t ruin it (but 60%+ of the time will ruin it). With this Supershieldz protector? Don’t even bother. Either choose to live with that particle under the protector or be ready to remove the film and try again (and again, if need be, since you have three protectors for each side of the Duo). SHOULD you successfully apply the film, no air bubbles and no dust particles, you’ll face one last challenge: finger smudges. The glass of the Surface Duo can collect finger smudges, but you’ll hardly see them when the screens are powered on. Not so with the Supershieldz’s protectors installed. After just an hour or two of using the Duo with the protective film, I could see smudges clearly on the black background of whatever was on screen. So, um, if you manage to apply the film without bubbles or dust, maybe only touch your Duo with library curator gloves?

Muy Buena compra. Cumplen con lo que prometen. Cómo trae tres por cada cara, es decir 6 en total, le puse hasta por detrás, se notan poco los orificios que claro están diseñados para dejar libres sensores de micrófonos y cámaras para la parte delantera, pero es poco notorio. Dejo fotos. Me queda un para para recambio más adelante.

I have been putting screen protectors on phones and other electronic devices for many years. This one is the worst I have come across in a long time. I got the screen protectors on the duo, and the sides keep getting air bubbles no matter what I do. I am on the second set of the screen protectors. I received them on Tuesday and had to replace them by Friday. 4 days. That is not good. It’s easy to get finger prints on it a day takes a bit to get them off. I will not buy this product again. Not worth the money, especially if the screen protectors need to be replaced every few days.

Me gusto mucho además son 3 pares de micas, hay de repuesto por cualquier cosa, excelente

Works as designed

easy to install, sensory is still as if nothing were covering the screen

Compatible and good quality material

Buena calidad y durabilidad