Black Guitar Effect Pedal knob

Found these to be very well made knobs. Used them on a PA amp and they work great.

I put these on a Fender red knob Super 60. They did not come with an Allen wrench but, my bridge saddle adjustment wrench worked just fine.

These are ok quality, but they have a hex key set screw and the correct hex key is NOT included. It would cost 10 cents to include one.

Came promptly (next day) and was as advertised.

small format, both width and height allow for easy adjustment of closely-spaced potentiometers, and the locking screw is low enough to capture the SHORT shaft of the stock trimmers, work better with aftermarket replacements. Also very well-priced

These are high-quality knobs for the money at first I thought the only ggot 9 and I needed 1more so the I gave was poor.review but when I installed my new chair today I found the 10th knob wedged in the back of my old chair so I did get 10 knobs after all My Bad the do look good on my Effect box and are much easer to read , So My Bad for not noticing the 10 feel old chair . So not my review is excellent Sorry for any confusion Best Regards

I needed some knobs. I liked that these had brass inserts, but I failed to pay attention to the matter of the set screws. What you get is black (hard to see) screws with a tiny hex socket (hard to fix an Allen key for). Compared with other knobs I've got with a similar profile. but with a good brass set-screw with flathead slot, these are not so good. The plastic around the screw-hole seemed a little rough, as well. I was limited to one of those right-angled Allen keys, which was difficult to use for these knobs: one quarter-turn, bank against the panel, disengage and reposition, repeat until done. It would be better with a screwdriver-like tool. They do the job, they're inexpensive, but I wish they were just a little better. Oh, and the provided product descriptiion says 'horsepower: 1hp'. I think mine might be underpowered :-)

Though the first picture shows an Allen wrench, know that the package won't include one; you'll get the knobs and a couple of extra set screws.

Le quedaron bien a un bajo Yamaha trb

I’ve had a lot of difficulty finding some replacement knobs for my Vox VT50 amp. I was really pleased when these arrived - the quality far exceeded my expectations, especially at this price. Honestly they’re nicer (and more effective) than the knobs they’re replacing.

アイバニーズエフェクターの小さいノブに被せるにはこれ！

These measure below 6.35 mm or 1/4 as they won't go on the potentiometer shafts. Measured with micrometer 6 mm.

Le quedaron a mi pedal Boss y a mi octavador marca ARION. Son funcionales, buena calidad.