ADE Crusader RD3-009 Red Dot + Rear Sight Optic Mounting Plate/Adapter for All Glock (Non-Optic Ready) Models & Taurus G3C, TX22 Gen2 – Motion Awake, 6 MOA, Dovetail Mount Base Included, Waterproof

This optic is great product for price. Very accurate. Very little adjustment necessary on my application. Ordered mine with mount. Mounted it on Taurus g3 Fired 5 shots before dead on at 25 yds. So far no issues after fifty rounds. Would highly recommend for anyone on budget needing red dot optic for targeting.

Bought this for a Taurus G3C based on video reviews I'd seen online for this exact red dot and the same model of Taurus. It was ordered on 11/29/20 and was finally delivered 3 weeks later. Not a great start, but I realize that USPS was overwhelmed due to holiday shopping. Installation was simple enough, but once installed properly, the quality was a real letdown. Zeroing it in (we've done this many times with other sights) was nigh impossible; regardless of how many clicks up or down we gave it, it refused to accurately zero. Also, once shooting the Taurus, the red dot immediately and repeatedly/reliably turned off after each shot. To turn it back on, holding a button for 3 seconds was necessary. NOT AT ALL what you want for this type of product. Scary to think about. This was returned, and unfortunately, the seller's label wasn't for UPS, so I had to pay almost $10 to ship the defective and dangerous sight via the USPS myself. Terrible experience overall. Amazon refunded the full cost of the unit (minus shipping) per usual.

Was pretty excited when I ordered it. I wanted to start upgrading my glock and wanted a quality piece with out breaking the bank, plus whatever I save on this will allow me to put towards another piece so I did my searching and found this ADE red dot to be that piece. It came with a mounting plate so I didn't have to drill my slide and had it mounted in 10mins. Super easy install and works great. I gave it 4 stars because the adjustments could of been a little more detailed like their higher end models but other than that little discomfort its great plus it comes with a cover to help it from getting scratched. I also like you can find youtube videos on it to help with any troubleshooting needed!

Love it

Excellent piece for the price so long as you do not bump into or drop weapon. This optic was simplistic and easy to use. Sighting is particularly easy, which is good because mine tended to require adjusting often. Target acquisition was excellent beyond 10 yards. The closer the target, the more difficult it became. In general, shooting competitively becomes more complicated when you have to remember several variables prior to squeezing trigger and you are under time restraints. All in all I would recommend this red dot if you’re on a budget but be advised that the materials used (aluminum) will not hold up to a fall of greater than 3 feet. Most surprisingly was the fact that mine made contact on artificial turf and sustained the damage shown below. Yet I would still purchase this odd item and most likely will to put onto a 9MM Canik I recently purchased and plan to competitively shoot in the future.

Easy to install and adjust, fit perfectly on my Taurus Gc3 pistol, very accurate and amazing value for the price!

Great red dot for the price! Easy to install, very good quality for the price! Fit my gen 5 Glock 45 very nicely with no issues!!!

Sat crooked on my Taurus G3 TORO. One of the pins on the bottom of the sight was offset slightly and wouldn't fit into my mounting plate. Causing the optic to sit crooked and not level on the slide. Poor quality control. Returned and decided to try another one. The second one red dot glass cracked within 200 rounds. Returned that one also. The power button is located on the front and is halfway covered by your slide. Unless you have one of them mounting plates that slide into your rear iron sight, but if you have an optic cut slide, this thing is stupid hard to turn on and off. Also the adjustment screws "lock screws" were located on the rear of the optic. If you have rear iron sights you won't be able to unlock those "lock screws" to zero in your optic. You'll have to remove your rear irons and then adjust your optic, and then reinstall your rear irons while your red dot is still attached. It's just an all around poor design. Just don't even buy this. I'm telling ya. I tried 2 different dot sights. And both were messed up and didn't work or broke. These might work for airsoft guns. But not a 9mm. Maybe there's some lucky ones that actually work without breaking. But I personally didn't get one. Wasted too much time dealing with returns and refunds when I could of been having fun at the range.