15Amp Circuit Breakers Thermal Overload Switch Protector 88 Series Manual Push Button Reset with Quick Connect Terminals and Waterproof Button Cap 32VDC or 125/250VAC 4PCS

installed one and it worked...but not sure till it trips........in any case, good value until otherwise.

These are excellent as tools to install while troubleshooting control circuits, especially when there is a short to be found.

The breakers were reasonably

Needed them to replace some bad breakers for the aerators on my Stratos fish n ski. Fixed the issue at a good price.

Well made not too big to take up a lot of room not cheap at all good for the money.

I used it to replace ATDR fuses from a custom electric controller. This breaker is half the price of a replacement ATDR fuse and does not need to be replaced (unlike fuses). Once tripped just push the button back, and you are up and running again. So far I have had no complaints from the product. Have used it at 3 places, replacing 2 AMP fuses with 3AMP Circuit Breaker/Overload Switches. Installation is easy, used a uni-bit to drill hole on controller box to fit the breaker facing outwards, so I do not have to open the box every time reset is needed.

They seem ok but they don't waterproof the enclosure therefore I had to return them. Otherwise they seem like a good product.

I needed something to connect to a 12 VDC windshield wiper motor to trip when the motor stalled (motor was not used for windshield wiping but a garage project). This breaker was perfect, tripped in less than 5 seconds after motor had stalled.