Hunter Sprinklers SGM Clik Rain Sensor Gutter Mount, Mini

This little but very important item helps me to enjoy my Mini-Click Rain Sensor. It is well made and worked perfectly for my type of rain gutters. If you were to read my review on my Mini-Click Rain Sensor you'd get a better feel as too why this is so important. Easy to install, simple in fact. Only a minute or two and we were ready to go.

This product allowed me to mount the Rain Clik rain sensor to the gutter and help to prevent my sprinklers from coming on during or after a rain storm - saving me money

I had a new roof put on our house and new gutters. When they were removing the old gutters they broke my original Hunter rain click sensor when it fell to the ground. I ordered a new rain click but it only came with the bars that screw on to the side of your house. You need to buy this SGM Clik Rain Sensor Gutter Mount to hang it from your gutter like my original did. You must remove BOTH brackets that come with the rain click. Then the two small holes will match. Some other reviewers only removed one bracket which is why they had trouble with the small hole on this bracket they didn't remove. All they had to do was to look at the picture in the instruction booklet.

I was worried about the hole location and diameter, but this is designed to connect to the Rain Clik device itself and not the aluminum extender arm that also can be used to drill into gutters and walls. It matches the old extension are that connected to the device 100%. It uses the smaller screw and lock nut that connects to the rear of the plastic Rain Clik. Note: If you are replacing one of the other arms, you may need to account for more wire or you may even run out of wire length or have no slack depending on what you are replacing.

Previously, the rain sensor was attached to the fascia using a bracket mount. To eliminate having the old bracket screwed to the new gutter, this rain sensor gutter mount made it easy to install the rain sensor. This appears to be made of aluminum alloy and should not rust. Not sure if the screws is made of stainless steel. Otherwise, appears to be of good quality and worth it. Recommend.

A fine product and well worth the price. On the plus side: easy to install and includes two types of mounting hardware; pre-wired; has an easy to use test button to assure that it is being read by your control panel built in to the unit; has a variable "dry out" control to adjust time interval following rainfall. Only thing on the negative side is that it could use a few more feet of wire but adding a little low voltage wire is not a big deal - just make sure that you use outdoor-rated wire. All in all, a very good buy.

The Hunter Sprinklers SGM Clik Rain Sensor Gutter Mount, Mini works to mount the Hunter mini-clik wired water sensor to a gutter after drilling a 1/4" hole in the bracket to match the hole in the sensor mount. The image shows the smaller hole on the gutter mount on the left and the sensor mount on the right. Obviously they are not the same. I drilled a second larger hole in the gutter mount and it was fine.

Was unsure if it would work for my Rain bird sensor or not but was a perfect fit. No drilling holes or modifications needed. Great product for gutter mount!